These thin sponges are excellent for flat scuff sanding. Although the abrasive may feel aggressive on the surface of the pad, the 10mm ProFoam These dense foam pads will scuff sand both flat and soft profiles. They will scuff sand without leaving deep scratches when 1/2” ProFoam Ability to shape itself to curved & round profiles while scuff sanding. A must for all profiles that are hard to sand without flattening foam allows for gentle sanding without leaving deep scratches on the surface. This sponge is great for sanding raw wood and finished surfaces.

This  abrasive is extremely long-lasting and maintains  an aggressive cut for the life of the sanding sheet. The red A/O abrasives are more water resistant than others, so they work well in humidity. These sheets can be used for stripping, prepping to bare wood, prepping for paint, sanding between coats, primer, and polish.

Easily transforms your abrasive’s ability to shape itself to a profile. These pads allow flexibility of flat abrasives (Paper, Film, or Screen) where SurfPrep ProFoam sponge’s cut rate isn’t enough. The interface pad can also be used with the sanding sponges when more depth or curve is needed. Recommended to be used with a J-Hook Backup Pad for best performance. 

Sheets These abrasives are amazing for quick stock removal. Made to attack gouges, saw marks, old finish, deep scratches and anything that requires quick removal. The f ilm backing resists tearing and leaves a uniformed scratch pattern. The white ‘sacrificial stearate’ prevents loading of material while sanding. 

These dense foam pads will scuff sand both flat and soft profiles. They will scuff sand without leaving deep scratches when sanding into deeper angles and profiles. Examples of use would be inside shaker door panels, beveled profiles on doors, sloped surfaces and curves. 

Made with a durable polyester material. The screen is full of tiny holes that are very effective for dust free sanding. It keeps materials from loading onto the abrasive which results in a smooth sanding pattern. This can be used for stock removal & stripping away old products like lacquer or stain. 

The pad saver is a thin shield. Like the name implies, it saves the red backup pad on your sander from premature wear, so the life of the Velcro feet stays fresh and firm for excellent adhesion between the abrasive sheet and the tool. It also helps the sander glide softer on the surface when sanding. Always use a pad saver when sanding with sandpaper (film, paper, & screen sheets).

Ceramic abrasives are made with incredibly sharp grains that stay sharp the longer you are sanding. The abrasive grains do not wear out or get rounded. When it breaks down, it is self-sharpening and will keep scratching the surface. These abrasives are ideal for very hard woods and some metals. 

 Ability to shape itself to curved & round profiles while scuff sanding. A must for all profiles that are hard to sand without flattening an edge. Because of its soft backing, it won’t aggressively sand away deep scratches, rough profiles, etc.  It is designed to ride the contour and scuff sand.

This backing provides enhanced support of grain and edge-wear for stock removal sanding, but at a less expensive cost than film or screen sheets. The grain provides a true, consistent & uniform scratch. Our innovative ‘load-free’ coating provides for a fast rate of cut and longer life. 

(Very Fine 320 Grit A/O)

Cleaning, wood finishing, automotive finishing, plastics Uses: Multi-purpose for a variety of sanding substrates. WHITE (No grit) -  These pads hold compound uniformly without saturation and will not scratch surfaces. Ideal for buffing with wax on wooden surfaces.